Hi Guys,
As shown below, I could create “figure 2”. But, there is challenge to add “text 2” and “text 3” which are out of “figure 2”. Would I get some ideas from you talented guys.
Thanks a lot
Archived discussions · Captured October 28, 2026
To add out of figure
Sorry to modify, I can create “figure 1”. text 2 and text 3 are located out of “figure 1”
Actually, the final UI looks like this one:
···
On Tuesday, December 4, 2018 at 10:28:29 AM UTC-7, peng wang wrote:
Sorry to modify, I can create “figure 1”. text 2 and text 3 are located out of “figure 1”
On Tuesday, December 4, 2018 at 10:26:02 AM UTC-7, peng wang wrote:
Hi Guys,
As shown below, I could create “figure 2”. But, there is challenge to add “text 2” and “text 3” which are out of “figure 2”. Would I get some ideas from you talented guys.
Thanks a lot
End of archived discussion · Replies are disabled